Direct naar de inhoud
⚡ Kritieke cyberalerts voor jouw sector & systemen — direct in je inbox. Aanmelden →
cybernieuws.nl Cybersecurity en informatiebeveiling nieuws alerts live · 5 min 127 bronnen 2 kritiek 2 vandaag
CVE's Videos Dagbriefing

← Terug naar CVE-database

CVE-2026-89946

NONE Gepubliceerd:

Beschrijving NL

In the Linux kernel, the following vulnerability has been resolved:

ASoC: cs35l33: drain threaded IRQ before runtime suspend

cs35l33_runtime_suspend() currently switches the codec into
regcache_cache_only(true) and powers it down without first quiescing the
threaded IRQ registered by devm_request_threaded_irq(). That leaves a
window where cs35l33_irq_thread() can still run after suspend has closed
off live register access. A running system can reach this during runtime PM while the driver still
has critical fault IRQs unmasked. If the threaded handler runs in that
window, it reads volatile INT_STATUS_1/2 after cache_only has been
enabled, ignores the regmap_read() failures, and can still drive the
AMP_SHORT_RLS, CAL_ERR_RLS, OTE_RLS, and OTW_RLS release paths. Use disable_irq() before entering cache_only/power-off so any in-flight
threaded handler is drained and no new IRQ thread can run during the
suspended state. Re-enable the IRQ only after runtime_resume() has
restored live register access with regcache_sync(). Since probe only
warns if devm_request_threaded_irq() fails, track whether the IRQ was
actually installed before disabling or re-enabling it.

Origineel (Engels) tonen

In the Linux kernel, the following vulnerability has been resolved:

ASoC: cs35l33: drain threaded IRQ before runtime suspend

cs35l33_runtime_suspend() currently switches the codec into
regcache_cache_only(true) and powers it down without first quiescing the
threaded IRQ registered by devm_request_threaded_irq(). That leaves a
window where cs35l33_irq_thread() can still run after suspend has closed
off live register access.

A running system can reach this during runtime PM while the driver still
has critical fault IRQs unmasked. If the threaded handler runs in that
window, it reads volatile INT_STATUS_1/2 after cache_only has been
enabled, ignores the regmap_read() failures, and can still drive the
AMP_SHORT_RLS, CAL_ERR_RLS, OTE_RLS, and OTW_RLS release paths.

Use disable_irq() before entering cache_only/power-off so any in-flight
threaded handler is drained and no new IRQ thread can run during the
suspended state. Re-enable the IRQ only after runtime_resume() has
restored live register access with regcache_sync(). Since probe only
warns if devm_request_threaded_irq() fails, track whether the IRQ was
actually installed before disabling or re-enabling it.

References