CVE-2026-43309
Beschrijving NL
In the Linux kernel, the following vulnerability has been resolved:
md raid: fix hang when stopping arrays with metadata through dm-raid
When using device-mapper's dm-raid target, stopping a RAID array can cause
the system to hang under specific conditions. This occurs when:
- A dm-raid managed device tree is suspended from top to bottom
(the top-level RAID device is suspended first, followed by its
underlying metadata and data devices)
- The top-level RAID device is then removed
Removing the top-level device triggers a hang in the following sequence:
the dm-raid destructor calls md_stop(), which tries to flush the
write-intent bitmap by writing to the metadata sub-devices. However, these
devices are already suspended, making them unable to complete the write-intent
operations and causing an indefinite block. Fix:
- Prevent bitmap flushing when md_stop() is called from dm-raid
destructor context
and avoid a quiescing/unquescing cycle which could also cause I/O
- Still allow write-intent bitmap flushing when called from dm-raid
suspend context
This ensures that RAID array teardown can complete successfully even when the
underlying devices are in a suspended state. This second patch uses md_is_rdwr() to distinguish between suspend and
destructor paths as elaborated on above.
Origineel (Engels) tonen
In the Linux kernel, the following vulnerability has been resolved:
md raid: fix hang when stopping arrays with metadata through dm-raid
When using device-mapper's dm-raid target, stopping a RAID array can cause
the system to hang under specific conditions.
This occurs when:
- A dm-raid managed device tree is suspended from top to bottom
(the top-level RAID device is suspended first, followed by its
underlying metadata and data devices)
- The top-level RAID device is then removed
Removing the top-level device triggers a hang in the following sequence:
the dm-raid destructor calls md_stop(), which tries to flush the
write-intent bitmap by writing to the metadata sub-devices. However, these
devices are already suspended, making them unable to complete the write-intent
operations and causing an indefinite block.
Fix:
- Prevent bitmap flushing when md_stop() is called from dm-raid
destructor context
and avoid a quiescing/unquescing cycle which could also cause I/O
- Still allow write-intent bitmap flushing when called from dm-raid
suspend context
This ensures that RAID array teardown can complete successfully even when the
underlying devices are in a suspended state.
This second patch uses md_is_rdwr() to distinguish between suspend and
destructor paths as elaborated on above.